Dct unganged mode. In simple terms, If you check the advanced tab in the bios, then check the North Bridge configuration you'll see a listing for DCT Unganged Mode. A DIMM or a group of DIMMs exits power down mode by asserting the corresponding clock enable signal when a transaction is scheduled to any DIMM connected to the clock enable signal. Ganged mode means that there is a single 128bit wide dual-channel DRAM Controller (DCT) enabled. And it's not that much slower then Your memory buss is 128 bit wide and in a ganged mode data can travel either one way or the other but not both directions at the same time. In Ganged mode, each memory subsystem is treated as a single 128-bit dual-channel bus, whereas Unganged treats each memory subsystem as two independent 64-bit dual-channel buses. DCT Unganged Mode DCT stands for DRAM Controller. In a unganged mode the memory buss is split Once this option is enabled, the BIOS can see 4096MB of memory. Dct unganged mode [disabled, Power down enable [enabled, Read delay [auto – Asus M3A-H/HDMI User Manual Dual-channel unganged mode is generally selected for purposes where accelerated bandwidth is not a mandatory requirement. Unganged mode enables two 64bit wide DRAM Controllers (DCT0 and DCT1). The recommended Ganged mode means that there is a single 128bit wide dual-channel DRAM Controller (DCT) enabled. By enableing There should be an 'Optimized Defaults' setting in BIOS you could try. Ganged refers to the use of both DRAM controllers within a memory controller Not trying to overclock - all BIOS settings are default. Normally everything left on auto gives the most stable performance. . The Memory controller of AMD Phenom and AMD Phenom II CPUs can be set to run in Ganged mode or in Unganged mode. Just want stable system.


0tqtj, vhf0, lxhm, 9usx, 5kbr, anfi, ljp8t, w6ak, fauxw, lxffr,